Hi all a question regarding the safe work load of threaded rods. Planning on installing threaded rod for hanging cable tray and light fittings off the cable tray. I was needing to know the safe work load of 6mm threaded rod = ??
8mm threaded rod =??
10mm threaded rod=...
Yeah so the set up that I have will be correct then. 185mm from generator Earth connection which is linked to neutral to my distribution board and then to M.E.T then bonding down the lifting frame to Earth aswell to keep all metals parts at the same potential? Is this correct?
Kind regards
Thanks Scotty for replying. The workshop DNO supply is a TNS earthing system. The workshop consumer unit is directly behind the generator other side of the wall inside the workshop. And I am going to be positioning my distribution board next to the workshop existing distribution board about...
Hi all new to the forum and electrican. Working on a plant at the moment where the client is wanting to have two 480volt 60hz three phases motors installed inside there workshop. These motors are going to be fed from a generator as they do not have enough power to feed them off the workshop...
