Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: vdim
  • Order by date
  1. vdim

    How to unlock electrical mapping corresponding attributes?

    Hello, I'm struggling with this thing: Documentation says: "The mapping definition can be set by the administrator. In this case it can also be locked." I managed to enter admin mode, however this setting to unlock keywords is nowhere to be found. Would be grateful for any tips here. Thank you!
  2. vdim

    NX11 "Swept" thinning between two identical sections

    Thank you Tomas! Now, by "the alignment between start and end section" do you mean the sketch orientation mismatch? (as a similar issue described in this thread: http://www.eng-tips.com/viewthread.cfm?qid=349853 )
  3. vdim

    NX11 "Swept" thinning between two identical sections

    Hello, I've run into a problem using Swept command (shown in the attached file). I need to sweep a constant circle section along a guide until the end of the second ark and then continue until the end of the guide resulting in the conical shape after the second ark. However, I get a non-linear...

Part and Inventory Search