Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Trusses at Non Load Bearing "Partition" Walls
We have had this discussion in our office as well... Following.- HK2013
- Post #2
- Forum: Structural engineering general discussion
-
Required Concrete Exposure for Boat Ramp
SlideRuleEra - By our estimate, the cost difference would probably be on the order of 8% of the concrete material cost for the higher strength concrete. We have provided this information and the risks involved to our client along with our recommendation of 4500psi, air-entrained and will see...- HK2013
- Post #7
- Forum: Structural engineering general discussion
-
Required Concrete Exposure for Boat Ramp
I was thinking the same thing about the durability. Fresh water, we are planning on a cofferdam during construction.- HK2013
- Post #5
- Forum: Structural engineering general discussion
-
Required Concrete Exposure for Boat Ramp
Howdy folks! I was wondering if anyone had any advice on the required concrete properties for a slab on ground boat ramp. The ramp is going to be half submerged and in an area where yearly ice is possible. The way I read Table 19.3.1.1 and 19.3.2.1 in ACI 318-14, since the ramp will be exposed...- HK2013
- Thread
- Replies: 7
- Forum: Structural engineering general discussion
