Thanks for your reply. I am looking for the allowable stress in RCC-M. The temperature is 300 deg, in ASME it states 116MPA. However, in RCC-M the AFNOR GRADE is Z6CN18.09 which I cannot find in Table Z. It is the straight grade for 304 - I have the equivalent for 304L although I would rather...
Hi,
I am trying to determine the allowable basic stress intensity (Sm) for stainless steel type 304. I have found the equivalent grade from ASME to RCCM which is Z6CN18.09, however, it is not referenced in the Z-Technical Appendices.
Has anyone else came across this problem?
Thanks
Hi Samu,
Thanks for your time, I think I have found a solution!
I believe the profile of the curve intersection with the straight line was too severe, this may have resulted in the simulation not being able to run. I have changed the profile and used a point on surface and it seems to run ok...
I believe my problem may have been slightly different to yours. I can get the curve on curve constraints for both the valve to rocker arm connection and rocker arm to cam.
It is when I try to add a second rocker arm to the cam that the solver locks up - did you have any problems when placing a...
Hi,
I have an assembly which I have placed a curve on curve constraint to one of the component parts. this solves fine and I can run the animation. However, once I place a second curve on curve constraint to a second part it will not solve and a 'RecurDyn Solver Lockup' appears.
what would be...
Hi all,
I am currently designing an over head camshaft with the relevant rocker arms. I have used curve on curve constraint within motion simulation to follow the profile of the camshaft once an acceleration has been applied - this works correct in animation. however, once I try to apply two...
