Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Jeb_46

    LOADS

    Hi to everyone, i ve this problem: i've defined 1 load step with 10 loads. I want to put all 10 loads in 1 load. It is possible to do it ? (without deleting them and doing it again). In hypermesh this is possible by ORGANIZE COLLECTOR. thank you.
  2. Jeb_46

    TRIM SOLID ABAQUS

    Hi to everyone, I have to trim a 3D solid with cylindrical geometry, in order to mesh a quarter of solid. I have to put symmetry constraints on the cut surfaces. which is the correct procedure for trimming the part? thank's to all.
  3. Jeb_46

    Hi to everyone, I need to select i

    Hi to everyone, I need to select internal surface of channels of a body valve manifod (3d solid) in order to assign the internal pressure. I can not select them by hand because the geometry is complex. there is a fast way to select these surfaces ? (for example: to generate a skin of 3D solid)...

Part and Inventory Search

Back
Top Bottom