I intend to plot the "Load vs percentage of interface cells killed" plot for a contact debonding simulation. The sample from a reference is shown in the image below. With the increasing load the number of interface cells/elements killed have also increased.
The simulation is working fine in...
I can have a try with down sampling my data points. I was wondering if this is the only way or still there are some other possibilities. I searched on internet and I found out that for MISO one can input data from yield point to the end point of fracture or till the ultimate strength. While as...
Thank you for your reply. I have already seen that video and the report which has been followed in the video. I have around 460 data points in the concrete compression test result. When I enter the data points (for Solid65 using TB command) and run the simulation I get the following error,
The...
In order to use Solid65 in Ansys workbench for simulating concrete, we shall define the multi-linear isotropic stress-strain curve as well. I have the concrete compression stress-strain data in excel. I would like to ask that how could I get the multi-linear isotropic stress-strain curve in...
thread569-332928
With reference to the said thread could someone please share commands for the SOlid65 material and cracking and crushing for concrete. I need to carryout simulation in Ansys workbench for concrete (mortar) material along with cracking and crack propagation. But I could not find...
