Search results for query: *

When I go to run a Tube program I get s file not found error. I am running SigmaTube on our Amada RI laser. Can anyone help? I'm not sure if I'm missing a sub routine or macro.

That was a good thing to check I found it to be something else. It must be in memory mode when you put last into lowest position.

Has anyone had experience with the FOMII3015RI rotary index. I am having and issue with getting i to automatically shuttle the index table in. I can do it manually but that is not the way it should be. I get an error code "EX0222 LST not in lower position" but all my lights are on for the LST...

I have tried with no consistent results. You can see it sometimes but it doesn't get deep enough. I also am still concerned about blowing a lens. Any extra advice from somebody would be great.

Yes, I can cut a 2" square @45 deg. No wave lines. I had to adjust the gantry on our other laser. Not too much fun but it worked. The laser head is tight and the springs and pin are in correct area. I still think material is moving and we need to program it different but my programmer is...

The part has a 0.020" gap in the middle. it is the same on the other side making is hourglass shaped. I'm trying to get the programmer to change how he processes the sheet. I believe material is moving but just wanted some extra input.[hammer]

I think it is the way they program the parts. I always program them to cut top first and then across the sheet. then downward toward the clamp. that way all the stress is relief is away from the part. If it is a joke I don't think it is that funny. The programmer is saying the Amada rep told...

My laser programmer and laser operator are struggling with cutting straight parts. The parts are 11ga CRS 3"x 30" rectangular blanks. When they pull the parts they come off in an hour glass shape. The mid section of the blanks are about .025" smaller than the ends. From my 20 yrs experience...