Search results for query: *

Please help me for the right choice of carrier growth, the following points need to be clarified . 1.What is the scope of a process Engineer in Advanced Process Control (APC) 2.Is it a good option to shift your job from Process design to Advanced Process control (APC) if you have a little bit...

I didn't mean to remind anything MJCronin. Apologize if you felt anything bad from me. All the responses were 100% useful.

Thank you Every one, all response where informative. I realise that, In main case "bimr" is on the money . "Economical Tank fabrication", ie. all other tanks are site fabricated while these tanks are shop fabricated which makes the deference.

In my case the ratio is well above 5%. Existing flare capacity is 35 MMSCFD and the the rated flow of new PSV is 24MMSCFD (governing case: Tube rupture)

Thank you George for your suggestions. Is there any possibility to get the spread sheet you are mentioning.

Thank you Emmanuel, Peak flow case of each Relief system connected to flare is taken as the governing case for Flare sizing. In the second point, Is it evident from any standards, to convince the client ?

My requirement is to add a PSV discharge to an existing flare system. My plan is to model the entire existing flare system and then check for the adequacy of the new one. What is the best way to model the same, is it by Modeling using Flare net or using Hysis dynamics environment.

What is the significance of Choosing optimum L/D Ratio in Atmospheric storage tanks.? As a normal practice the L/D ratio of atmospheric storage tank is considered within the limit of 0.5 to 1.1. However, it is noticed that for some tanks it doesn't follow this limit. For example, fresh Amine...