Can anyone tell me how i can draw split lines in an 2D axisymmetric nonlinear simulation. I want to do this in order to use the mesh control function on them, to increase the nodes in the critical areas, and reduce run time. I am using SW 2016.
drawoh: I live in norway and these kind of courses are not exactly readily available, and all online courses i have found only apply to ASME Y14.5. And i want parallellism as stated earlier.
I agree the that it is more logical to use a flat surface as the datum, using the surface between the...
Hi, I have a question regarding how to use the paralellity control on multiple features in a section view (see attached picture).
I want the top of each ridge to be within the same tolerance planes. The way it is illustrated on the attached drawing is how i think it should be, but i am very...
Okay, thank you so much for your help. It is apparant it is many things i dont understand about geometrical tolerancing yet. I actually have some questions regarding paralellity of multiple features too. I will make a new thread about it soon, hopefully you can help me there too.
Thank you very much for your reply. Using the circularity form control was only to control the OD.
But for my next question, shall the OD and ID dimensions now be Theoretically exact dimensions (TED)?
Thank you for reply, but that doesnt really answer my questions. It would be great if someone could just show me the correct way to use the symbols on my drawing.
Okey, but if i then use a circularity tolerance on the outer diameter. Then use this as a datum for concentrisity on the inner diameter will that be more correct? Then i am sure that both ID and OD are toleranced? See attached picture
Also using the OD as the datum, this references the...
Hi, i have a question regarding concentricity i hope some of you can help me with, i use ISO GD&T
I want 2 concentric circles to have be be toleranced concentric to eachother, to make sure they have the same center according to eachother. How shall this be illustrated? I have atteched a drawing...
