HI All,
Im designing a cold room that will operate at - 4 farenheit. Local Climate all year round its warm : min 79 F mas 120 F
For Walls and roof will use expanded polystyrene Sandwich panels
Under the concrete Slab we will be using 2 layers of 2" of expanded polistyrene + Vapor...
Hello All,
We want to rebuild our atlas copco GA 75 compressor , we already have all the original bearings and parts required .
I have not been able to find any manual with the tolerance and torque specifications
Any advice?
Thanks in Advance
Alex
PROBLEM SOLVED!
We finally were able to get the generator running under load!
As mentioned before we were getting High Air Temp in the intake manifold. Today we inspected again the complete cooling system.
Our engine is equiped with a coolant overflow valve that controls the amount of flow...
Hello all and thanks for your posts
Today we did two new tests:
we used an old school pressure gauge to compare the readings of the control panel , conclusion manifold pressure sensor its OK
Later during the day we found a new Air Temp/ Air pressure sensor and run a test. Result was the...
Hello All,
Thanks for your advice, I will make a list of the things we have done to the moment:
1-) Fuel System : our first Idea was to the check fuel for contamination or obstructions in the line. Everithing was checked and no problems were found . We even changed the 2 fuel filters. Old...
Hello,
We have a stand by 750 KVA Generator ( Marathon Electric / Volvo Penta Power ) 900 hours of use.
MTU
Model 660RVC6DT2
Engine TWD1643GE-VOLVO
The generator will run smothly when no load its applied. After a few minutes of working with load ( even 20% of the generator capacity) the...
