Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Feeder screw/auger thrust load
Hello all! one other person and I are responsible for designing a silo with two discharge screws at the bottom. Each screw is supported by the shroud on one end and a spherical roller bearing on the other. CEMA standards have provided some design guidance for our silo, but one issue we are...- Noordel
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
-
chemical composition
Hello, I'm looking to select the correct material for some pipes and fittings. The liquid that will be pumped through these pipes and fittings is unknown in terms of what its made of chemically. Where can I get this liquid tested to determine its chemical make up? or is there a way for an...- Noordel
- Thread
- Replies: 4
- Forum: Chemical engineering other topics
-
304 vs 316 stainless steel
Hello, I'm looking to find a sound reason to use 304 or 316 stainless steel pipes and fittings for a plumbing system. The product we are pumping through the pipes has a Safety Data Sheet. As an M.E. just starting out, what tools can I use to confirm these pipes will not corrode? Thank you- Noordel
- Thread
- Replies: 3
- Forum: Water treatment & distribution
