Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. FIREotter

    Inertia Wheel/Reaction Wheel motor to flywheel attachment and fit.

    rothers (Mechanical)28 May 19 11:21 What's the existing drawing specification (Dia & Tol) for the flywheel hole ? I'm not sure, I have no access to the original drawings, I'd estimate they've been speced at 1.6mm +-0.01 by feel of the fit. Jboggs (Mechanical)28 May 19 12:00 If you end up...
  2. FIREotter

    Inertia Wheel/Reaction Wheel motor to flywheel attachment and fit.

    Thanks rb1957, Yeah, the wheels are being glued in house, I suggested sending them to the vendor, but it seems that isn't an option. I'm not sure how they're pulling them off, I've mentioned that any kind of pulling is a bad idea and highly likely to damage the motor bearings unless they have a...
  3. FIREotter

    Inertia Wheel/Reaction Wheel motor to flywheel attachment and fit.

    x-post from Aerospace I'm helping out with a little bit of design work at a small aerospace company, they've just lost there full time Mechanical engineer and are having a number of issues with some parts turning up. One of these parts are brass flywheels for an inertia wheel model. The...
  4. FIREotter

    Inertia Wheel/Reaction Wheel motor to flywheel attachment and fit.

    I'm helping out with a little bit of design work at a small aerospace company, they've just lost there full time Mechanical engineer and are having a number of issues with some parts turning up. One of these parts are brass flywheels for an inertia wheel model. The motors that are being used...

Part and Inventory Search

Back
Top