Thank you for your help, I have attached the input file.https://files.engineering.com/getfile.aspx?folder=d0fe291c-e499-493f-bfc2-1dc37123b1e7&file=Mowag.inp
When I check the results, I notice that only the first layer of seeds of the mesh is affected by the heat flux acting on that surface, the other layers remain at the initial temperature and are not affected at all even if I modify the duration of the simulation. If I change the size of the...
I thought too that it should be transient, but in every tutorial they use steady-state, so I opted for that. Also, when I change it to transient, the results are even worse.
I have tried to change the heat flux (the load) from total-flux to uniform distribution, and now on the surface I obtain...
Thanks for the reply.
I have tried to apply the convection and radiation only on the surfaces where the heat flux is not applied and remove the structural BCs. However, the results are almost the same, just the highest temperature now is around 30 degrees Celsius.
Do you have some suggestions...
Thank you very much for your answer.
I have checked the units several times, cause I too thought that I made some mistake there, but everything seems to be correct.
I am performing a thermal analysis, I just used static BCs as I thought they were necessary due to the deformation of the part...
Good afternoon,
I am new to Abaqus, and I am trying to perform a thermal analysis on a section of a ventilated brake disc.
So far, I have followed some tutorials on youtube about generic thermal analysis, so I've defined some properties of the model such as material, section, instances, loads...
