Hello,
I have problem with bystronic laser 3015, last week electricity power went out few times and after that cnc 90 software cant start anymore. I doubt that maybe memory on one card in the computer on which is instaled software is cleared after that electricity problem. That is special card...
At 100% it shows about 80 on the current, but i have noticed when power go over 80% power the current are not stable, and goes a bit up and down..
We have checked gases and its ok,
turbo was changed about 8 years ago and installed new one, its ok.
Water flow is 80
We didnt check voltage at the...
hello, i have problem with bystar 3015. When we cutting at 100% power the power at small display write only 1350W istead of 2800w. We can not cut thicker material of 5mm.I have checked high voltage lamps and its all ok.Check all mirrors and it seems to be ok.
Does anyone can help?
