Search results for query: *

Dear All; I will make a structural analysis for a spherical vessel located undergroung. how can I take into account soil load for structural analysis? Is there any example in ASME Sec VIII div2. or in any different standart? thank you in advance.

Dear All Experts; I have examined a welding analysis. I used Goldak's Double Ellipsoidal model in APDL for moving heat source in transient thermal analysis. I imported the loads obtained in thermal analysis to structural analysis. I divided the weld line with 10 parts, the length of part 100...

Dear Experts Yes I have found Yield stresses value dependent on temperature Asme Section II Part D table Y-1 but Could I find tangent modulus?

Thank you for your advise Chrisine...

Thank you for your advise Luis.

Dear all experts, I am trying to simulate the welding process of SA 387 GR Cl 2 material using FEA. But I need the Yield Stress of SA 387 varied with temperature also I should use yield strength as dependent on time. Where Can I find out these material Properties? Best regards...

Dear NRP99 thank you for your reply and suggestion. I read a lot of paper and articles about welding and residual stresses but I have not seen any paper related SA 387 GR 11 C2. thermal and mechanical properties in BPVC Section II Part D Properties till 800 C. thank you again for your reply.

Dear All Experts; I am trying to make a welding analysis for SA 387 GR 11 material. and to complete this analysis I need the thermo physical and mechanical values of material SA 387 GR 11. where can I find out these values. I would appreciate it if someone could give some suggestions Best...