Our B-axis servo amplifier stopped working and needs to be swapped out. I understand that the b-axis will need to be recalibrated after the swap. Does anyone have or is anyone willing to share the procedure to recalibrate this axis? Our laser is an Amada Pulsar 2415 aII. Any help would be...
That is what I am thinking as well. I have long wondered if my laser software actually looks at the edge/approach data. I had a laser engineer in to help with cut conditions when we bought the machine and he seemed to think that the machine was not using them even though we had them set up...
Any suggestions on how to get the underside of my cut to become more square like the top side of the cut? This is 1/2" AR500 steel. My limitations are that I can not change the dimension of the square hole or its fillets on the corners. I am cutting with a 7.5 inch lens, 3mm nozzle and below...
The task is to cut an irregular shape out of the sheet. The large hole is where I start to pierce. The laser will start a ramp pierce and then blow out. This happens some times. I have not tried changing the direction but I do believe the laser to be centered well if that is what you are...
We have an a 2000 watt Amada Pulsar 2415 AII. I am randomly getting these blow outs during my pierces in 3/8" and 1/2" material. Obviously I would like to eliminate this from happening. Can anyone help me out and offer some insight on why this would happen? I don't notice any discernible...
