Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
When to use bearing factor?
I'm looking for some guidance on when to use the bearing factor that is presented in MIL-HDBK-516C, Section 5.3.3.f (copied below). MIL-HDBK-516c, Section 5.3.3.f: The design stress values for bolted joints with clearance (free fit) that are subjected to relative rotation under limit load or...- KSMTNBKR
- Thread
- Replies: 2
- Forum: Aircraft engineering
-
Material Allowables Question
I want to use 4140 Steel Plate per ASTM A829, but I can't find strength allowables (Ftu, Fty, Fsu, all that good stuff) for this spec. I do have material allowables for a different spec, which are MMPDS allowables for AMS 6395. But I'm not sure if these allowables apply to ASTM A829. My...- KSMTNBKR
- Thread
- Replies: 2
- Forum: Aeronautic & Space engineering general discussion
