Thank you all for this inputs.
As per AMSE Figure UW-20.1, all the welds are acceptable for strength weld. But their are not described in more detail. So I wondering wherever to use only fillet weld or groove weld. Is there an issue that the tube will stand out of the pipe? We are buying heat...
Dear all,
In ASME BPVC.Vlll.1-2017 Figure UW-20.1, there are acceptable welds. Is there any recommendation if one weld is better than the other or is this depend on the welding process? Do you have any recommendations, which one to use?
Thanks for the help
Thank you @ironic metallurgist.
The concern is that we create a water hammer in the compressor.
Of course we design the Cooler as best as possible, this issue was coming up from a HAZOP.
In cooler with gas pressure higher than water pressure the scenario of a tube failure has to be taken into...
Dear all,
I have a Shell and Tube heat exchanger. Process gas on Tube 0.5barg, cooling water 5barg on shell side. Temperature of Gas inlet 170°C outlet 35°C.
How can we avoid that water entering the following Process equipment (compressor) in case of a Tube failure?
I can not reduce the...
