Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. adhikasn

    Hello ABAQUS Users, I'm doing a FE

    As I'm doing an explicit analysis. I used c3d8r and c3d6. But the problem still remains.
  2. adhikasn

    Hello ABAQUS Users, I'm doing a FE

    I did that. I did compression test, 3 point sending test and pushout test. It's working fine on all of these cases but in the bending test I'm having this problem.
  3. adhikasn

    Hello ABAQUS Users, I'm doing a FE

    Hello ABAQUS Users, I'm doing a FEA of composite beam of 54 MPa concrete using CDP model. I'm facing a problem here with the material not behaving according to the given input parameters. In the beginning phase of the analysis itself (after 41 MPa) the stress starts exceeding as can be seen in...
  4. adhikasn

    1 material point failed to conrge

    Hello ABAQUS Users, I'm trying to run a simulation of a pushout test with steel deck in ABAQUS Explicit. I'm using CDP model for the concrete behavior. However, I'm facing a problem with it. I'm doing it for 50 MPa concrete but after some time some elements in the concrete exceeds the yield...

Part and Inventory Search

Back
Top Bottom