Hi all,
I am familiar with asme code for tube to tube sheet joint but don't know any thing about EEMUA PUBLICATION 143.
Is there any recommendations and restrictions for quantity of tube to tube sheet joints?
Specialy want to know about cross section of joints like how many tube require for...
@
Please refer QW-124 & WW-303.3 of ASME Sec.IX for Special Position.
That position which not covered in QW-120 to QW-123. Means all figure of position
Hi
Please refer QG-109.2 of ASME Sec.IX.
You will find defination for same.
Refer defination for "weld size : groove weld"
"The depth of chamfering plus any penetration beyond the chamfering, resulting in the strength carrying dimension of the weld."
It means its depand on your TTJ joint...
Hi,
I m refering UG 79 for dish end forming of material SA 240 316 L.
When I refered UHA-44 for heat treatment , u noticed there only 25 grades of stainless steel given in table UHA-44 and SS 316 L not listed in it.
Now what to do ???
It means Heat treatment required for material not listed in...
Thanks Mike for the reply
Hey I m looking to PCC-2 for repair work for such kind of issue , but the question is ' can I use PCC-2 for repair work because didn't find any reference for PCC-2 in Section VIII Div.1.
Hi
I need to know if any guidelines provided by ASME Sec.VIII Div.1 for below cases,
Case-1
If wrong opening happened anyhow (opening more then 100 mm) cylindrical shell, can we do patch welding as per Code ?
Case-2
Asme code allowing maximum 60 mm dia spin hole for thickness more then 10 mm...
