Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Hill Mary
  • Order by date
  1. Hill Mary

    Software suggestions for Standard Operating Procedures

    MIE Trak Pro is best for this. https://www.mie-solutions.com/mie-trak-pro
  2. Hill Mary

    OEE assets measure at refinery industry

    Overall equipment effectiveness (OEE) is the premier standard for measure. is used as a benchmark to compare any given production to industry standards, in-​house. were constantly reacting to unscheduled downtime on certain assets; and the. However, it is also often used in refineries to help...
  3. Hill Mary

    How to determine bushing bearing wall thickness

    Thick-walled bronze bushings feature a standard wall thickness between 0.0625 and 0.156 inches. thin-walled plastic bearing vs. thick-walled bronze bushing. Find out more about how plastic bushings can replace bronze bushings. https://www.mie-solutions.com/mie-trak-pro
  4. Hill Mary

    Industrial Fibre Optic Laser

    No no, you can't repair it. https://www.mie-solutions.com/mie-trak-pro
  5. Hill Mary

    digital vs analog signal cables

    The big difference between Analog and Digital is how the signal is transmitted from the source to the TV in your home. Analog TV's transmit audio and video signals over the airwaves in a manner similar to a radio signal. A Digital TV signal, on the other hand, transmits in “packets” of...
  6. Hill Mary

    Sixnet Protocol

    The sixnet ethertrak unit failed on SMOKEY on Aug 2018. It was replaced using ... Setup - You must use SixNet's io_toolket to setup and configure the SixNet Hardware. ... Configure network parameter. Connect ... Universial Protocol - SixNet's Universial Protocol (SUP) is their proprietary...
  7. Hill Mary

    General Rule: Minimum Thickness for Threading

    It is commonly known that the minimum recommended thread engagement to make a strong connection for a component with a tapped hole is approximately 1 times the nominal diameter in steel and 2 times the nominal diameter in aluminum. https://www.mie-solutions.com/mie-trak-pro

Part and Inventory Search