Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Reduction of Standard equal tees (ASME B16.9) by removing 10 mm from "Run length"
On a particular job , because of space constraint, it was required to cut exiting 6" equal tee by 10mm on the "run length" of 143mm . Therefore this dimension was reduced from 143mm to 133 mm at site. This was for 150# rating line. 1) Is cutting of standard fittings(ASME B16.9) allowed? 2) how...- ASDcunha
- Thread
- Replies: 4
- Forum: Material engineering general discussion
-
Reduction of Norsok Compact (L-005) Flange length from 75 mm to 55 mm by cutting 20 mm
On a particular job, to provide clearance and avoid clash, it was required to reduce a 6" , 600# Norsok-L005 standard compact flange length from 75mm to 55mm by cutting 20 mm. 1)Is this allowed? 2) How does one validate that this design is acceptable. refer attached file for...- ASDcunha
- Thread
- Replies: 2
- Forum: Material engineering general discussion
