Thanks Mariofeliciano, I think we have dialed it in now but I don't remember off hand the settings we came up with. Our controller is an old 160i-L so you're years ahead of us. Our service tec had discovered that when they replaced the Z servo, they installed it one cog off, so no matter what we...
Thanks guys, we found a setting we liked and ran with the 1500 watts 1000 hz and duty at 25. That produced the cleanest edge on the vinyl.
The vinyl just barely started to burn/spark at a duty of 20 on our machine and going up to 35 duty really gave a rough distorted edge to the vinyl that was...
Thank you laserninja. I believe you are dead on but our machine is a few years older and only has the 101, 102, & 103 for a pierce. We will be trying some etch settings in the next day or two. Ill post the results when we do.
Hello, Need help with laser paper issue. I just bought an old 4000w CO2 Amada FO3015 and I cant find any information or settings to preburn the protective vinyl film along the cut path. The material we need to run is 18ga 201 stainless and removing the vinyl film is not an option for us. We have...
