Hey everyone,
I've been working on a structural model in SAP2000 and have encountered a peculiar issue that I hope someone can help me with. I am trying to apply moment releases to certain points in my model, but I find that while some points allow for moment releases, others do not.
Here’s...
1503-44 Yes, you are correct. However, I will have to purchase a pump that is strong enough to get the job done while also managing the cost of the pump. Therefore, I need to know that what I am purchasing is good enough.
The hand pump will take too long to compress all the air with all the water in the coil. Removing as much air as possible before using the hand pump will make it easier and faster.
I'm conducting a hydro test on a coil system and need guidance on determining the appropriate pump size. The objective is to pump water through the coil with a flow rate sufficient to eliminate air pockets that tend to form at the top of the coil (see yellow in image below).
Here are the...
