Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
GD&T tangent modifier with profile tolerance?
Makes sense. Thanks!- JLS357
- Post #7
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
GD&T tangent modifier with profile tolerance?
Thank you all. I'm hearing essentially the same thing from everyone, and that is the datum plane is already understood to be tangent to the three outer-most points of the nominally flat surface. It appears I was trying to over-complicate a simple situation and had forgotten a basic principle...- JLS357
- Post #5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
GD&T tangent modifier with profile tolerance?
Hi All. I’m a long-time reader of this forum but a first-time poster, and I’d really appreciate some GD&T help. Id’ like to use a tangent modifier with a profile tolerance if it’s permissible and if I can figure out how to properly apply it. I have a situation where the design is an assembly of...- JLS357
- Thread
- Replies: 7
- Forum: Drafting Standards, GD&T & Tolerance Analysis
