So, just to be clear, there could never be a combination of the two eccentric axis’ like that to form a common datum, in this case A-C? Is that type of combo even possible? Would that make a plane?
Where can I read more about these defaults?
Is that an ISO thing?
What would I reference as the datum for the angle callouts for the flats?
and... how would I reference the... zero angle for the vertical flat?
Just sort of stuck on how to create the callout that compares the flats to the eccentric portion.
Howdy all.
Would the following work to control the orientation of these flats to the 2 axial datums that are offset?
If I have datum A establishing 1 axis, datum C (eccentric portion) establishing the other axis.
Then referencing A-C as a common datum to establish clocking of the shaft and...
