Thank you for your reply.
When I run the first simulation with the same MS setting (5E-07), the simulation runs to convergence with ok results.
Then I set up the import simulation and use the same MS. Since material properties and geometries are the same, shouldn't it work the same?
Thanks.
Hello everyone,
I am having an issue with doing an import analysis between Explicit simulations.
The simulation stops after the first increment because the ratio of deformation speed to wave speed exceeds 1.0000 in at least one element in one of the imported instances.
It also shows that the %...
Thanks for your reply.
Yes, the surfaces and sets between the two analyses should be the same.
That is what I did, I opened the original .cae file and then edited it. The only difference is that I need to import the deformed mesh of two parts, because I need to position other new instances with...
Hello, I am trying to do an import analysis with Abaqus CAE. I simulated some steps with the Explicit solver, now I need to import 2 deformed parts with the initial state in a new Explicit simulation to simulate additional steps.
I imported the deformed mesh from the last frame of the...
