It's a little bit of both. We're modifying the inspection procedure to only check the minimum dimension (we use a GO gauge to check low end of ID), but as such we don't want to leave the maximum dimension unlimited (i.e. with only a MIN annotation). It sounds like the option to update the...
Hi @r6155 — Thanks for the response! The issue is that we don't want to leave the high end of the tolerance unlimited. My understanding is that by using the "MIN" notation, there is no limit on the high end of the dimension. Is this correct? We would like to still keep the block tolerance of...
Current State: We have a tightened tolerance on the high & low side of a dimension and we do a finished good inspection on both the high & low end of that dimension (with Go/No-Go gauges). See screenshot.
Desired State: Remove the tightened tolerance for the high end of that 9.64mm dimension...
