You are absolutely right! The point is to make a hole with diameter 2xThickness!
material thickness is 1mm
bending radius is 1mm
hole diameter is 2mm (punching tool diameter, 2xThickness)
k-factor is 0.5
Thank you!
I would like to create a non-welded metal sheet box which have third flange instead of close corner connection.
Sure, there is no problem to make it but finally SW doesn't allow me to connect three flange together! I have to make a possible small clearance at connection. I have to create a...
I am using Revision Manager to explore the contents of assemblies. Sometimes I need to open included subassemblies and parts in SE. I am choosing the position from file tree then I push “Open in Editor” toolbar and the top level assembly will been opened at SE. That is really inconvenient to...
