Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: zneip
  • Order by date
  1. zneip

    Riks method

    Dear Abaqus users. I have couple of questions regarding the Riks method. 1) When applying gravity and a concentrated force in the Riks step, will both loads be multiplied by the load proportionality factor? Meaning: must gravity be applied in a step before the Riks step? 2) In CAE (6.3-1), is...
  2. zneip

    Connector for hydraulic cylinders i CAE

    Dear Abaqus users. I'm doing a postbuckling anlysis of an offshore crane, and I use ABAQUS 6.3-1 CAE. My problem is concerning the hydraulic cylinders. The elactisity of these is known, and I assume they can be modeled using connectors. What connector/proporty would be suitable to do this...
  3. zneip

    Unconnected regions in part imported to CAE

    Hey. I have imported a shell-part from solidworks to ABAQUS 631 CAE, and when i try to run the job it says: "There are 14 unconected regions in the model". Are there any possibilities to conect the shells in CAE? If not the only solution seems to be creating the part in CAE. I...
  4. zneip

    Partition/Mesh

    hey. I have imported a shell part from SolidWorks to ABAQUS 6.3.1 CAE. In the process of making a valid and precise part i have deleted/created many faces. This has resulted in many partitioned edges wich leads to nodes on these points when i mesh the part. Are there any possibilities to make...
  5. zneip

    Beam\Shell connections in ABAQUS 6.3 CAE

    I'm going to do a non-linear buckling analysis of an offshore crane with ABAQUS 6.3.1 CAE. There are L-beams conected with the sideplates going from one bulkhead to the next. Beam properties can only be assigned to wires, and I can not create a wire on a shell. Creating a wire from bulkhead to...

Part and Inventory Search

Back
Top