Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Air Lift Pump Design
I have a situation where it it agvantageous to have an air lift inclined at (Approximately) 60 degrees from horizontal. The scenario is located in a wastewater clarifier, domestic sludge. In leu of cross bracing the tank, I was wondering how air lift pumps will perform at 30 degrees off...- YOUNGGUN
- Thread
- Replies: 6
- Forum: Waste disposal & treatment
-
AIR LIFT PUMP DESIGN
Sorry, I posted this in the wrong forum..But I don't know how to remove it.- YOUNGGUN
- Post #2
- Forum: Water treatment & distribution
-
AIR LIFT PUMP DESIGN
I have a situation where it it agvantageous to have an air lift inclined at (Approximately) 60 degrees from horizontal. The scenario is located in a wastewater clarifier, domestic sludge. In leu of cross bracing the tank, I was wondering how air lift pumps will perform at 30 degrees off...- YOUNGGUN
- Thread
- Replies: 2
- Forum: Water treatment & distribution
-
WATER TREATMENT QUESTION
IT IS UNDERSTOOD THAT WITHIN A WATER SYSTEM ANY INCREASE IN Ph WILL ADVERSLY AFFECT any CL DISINFECTION CAPABILITIES; THEREFORE pH MODIFICATION SHOULD HAPPEN AFTER THE DISINFECTION (i.e. CONTACT TANK EXIT) IF AT ALL POSSIBLE. I PLAN TO INJECT ORTHO & SODA ASH AS A REMEDY TO A CORROSION ISSUE...- YOUNGGUN
- Thread
- Replies: 0
- Forum: Civil/Environmental engineering general discussion
