Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. venghatesan

    Selection of Material for Tappets

    Hi Cory, I found your information valuable. Thank you for the same. Can you please elaborate on "low-friction coatings like Diamond Like Carbon, etc." Is it similar to "Molycote", used by Toyota and other Japanese OEs?
  2. venghatesan

    Laser Marking

    The component is an Engine Tappet, with an OD of 30mm. Its just like a cup and the top face of the cup needs the Surface finish reqt of 0.1Ra. The volumes are 3~4 Millions/annum. Some amount of automation, if not fully is acceptable.
  3. venghatesan

    Laser Marking

    Hi, I need a machine to measure a particular dimension and mark a corresponding number on the component according to the dimension measured. There are 33 variants of identification numbers possible based on the dimension measured. Can you suggest such kind of a simple machine which would do...
  4. venghatesan

    Equivalent material for Sintering

    Dear Experts, We have a forging in SAE 1541 material, which is a carbon Steel. Due to the intricacies of the part, higher volume as well as the special machining requirements such as broaching, we are planning to get into the Powder metallurgy route for manufacturing. We also need to propose...

Part and Inventory Search

Back
Top