DIAMONDJIM - can you just go through that trick with the pins in a bit more detail please... I think what your trying to say is place 2 pins against the bottom land of the external spline, and from this i can calculate the major diameter for the internal spline? is that right?
Thanks for all the help guys! I'm new to this game, but learning as we go along. I'll do some homework and find the other parameters you mentioned gearguru.
I'm not sure about the "side fit" or "OD" fit - but the splines engage without needing any force. Instinct tells me...
Hi, i need a 2D drawing of an involute spline in order for me to be able to cut the internal spline using wire EDM... I understand there is software available that can help with such a task? The spline in question is:
no. of teeth = 18
P.C.D = 1.125"
D.P = 16/32/80
P.A = 30 degrees
I...
Hi there, im new to this forum so please be patient with me! I am looking for some advice regarding driveshafts/splines from an ATLAS axle. This is the rear "live" type axle, I don't know how familiar you will be with these, they were standard in Ford capri's, transit vans etc etc over...