Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. johnparr

    batch IDEAS cgm to pdf convertion program?

    Thanks! -John
  2. johnparr

    self-clinching 0-80 stud for .012-.015 stainless??

    I need an 0-80 self-clinching stud for .012 thick stainless steel sheet. Does anyone know of a source? Thanks John
  3. johnparr

    SE vs SW - any informed opinions?

    I'm a few months late on this but I have used IDEAS, SE, SW and am just picking up Inventor. I tend to agree with Binary about SE, SW and Inventor all having good capability. Algor offers an FEA package now that links directly to Inventor for about $4000 - a lot less than the integrated...
  4. johnparr

    double-motor gear drive

    Thanks for the posts! Plasgear: Do you run your DC motors from the same current/voltage drive? If so, are the motors wired in series with each other or in parallel? Thanks John
  5. johnparr

    double-motor gear drive

    I have an application where I need to supply 75 watts of power to a gear from a DC brush commutated motor-driven pinion. However, I cannot fit a 75 watt motor into the available space. I can fit two 45 watt motors into the space, with both motors driving the gear with identical pinions. The...
  6. johnparr

    batch IDEAS cgm to pdf convertion program?

    We have several thousand .cgm drawing files that we are converting to .pdf(1) format. It is currently being done manually and is very time-consuming. Is an EDS or third-party software package available that does batch conversion of IDEAS cgm drawing files to pdf(1) format? Thanks -John
Back
Top