I have been analyzing a simple 4-member, gable portal frame, pinned at each base connection and loaded with uniformly distributed roof loads only(i.e.: no lateral wind or seismic).
Calculated by hand using moment distribution I get a solution for the eave and peak rigid connection internal...
As Homer Simpson says: "Doh!"
When I tried to uninstall Acad I quickly realized I had performed a Windows no-no by copying the ProgramFiles\Acad2000 directory from another HDD!
A true install now works perfectly.
Thanks for the reply.
All attempts to run the unrecognized commands have been through the pull down menus.
UNITS, DDUNITS, _.UNITS, ~UNITS or 'ddunits didn't work.
Manual menu load didn't work either as "APPLOAD" was also unrecognized!
I'll try uninstall/reinstall.
I have ACAD 2000 installed and 'running'on an XP Pro machine, however numerous commands yield the following error:
Example: 'Format Units': '_units Unknown command "UNITS". Press F1 for help.
I've tried Windows 98 Compatibility mode, but this gives FATAL ERROR, and does not work.
This is...
The NFBA's Post-Frame Building Design Manual states that Table 6.1 'represents a small percentage of available data' yet I am having an extremely difficult time in locating any data or design examples for metal clad endwalls. (The design example at the end of the manual estimates endwall...
I am running Solidworks on a Dell Latitude CPi R400GT with 128M of ram. I have installed all of the latest bios, video, etc.. drivers and am still experiencing alot of crashing problems.
Is anyone else out there have any ideas? I obviously can not change graphics cards!
