We are having large steel pistons for landing gear go out of round during baking or shot peen, is there any guidance on use of holding fixtures such as used in heat treating?
Jim
Anyone have any idea on use of fixtures during baking, our large gear pistons are going out of dimension during bake. The same would apply to shot peening. Where would I find the use of fixtures during stress relieve????
Thanks, Jim
The FAA benchmark can be found in Chapter 4 of AC 43.13-1B. While this is acceptable data, as opposed to "approved data" it is s a good description of both types of fasteners. However, if a manufacturuer issues a specific repair, using a specific rivet, then that would over ride the...