Search results for query: *

Thankyou for your replies. A thermite reaction is considered the most likely cause - but there are some contraindications. 1. This was the first time the joint had been split since construction (3 years ago) and there was little or no visible evidence of rust. 2. Thermite reactions, as my...

Has anyone heard of the following occurance: Burning embers dropping from bolts upon on breaking of flanges. Rough details are as follows. Vessel side flange coated with thermally sprayed Aluminium Pipe flange uncoated carbon steel. Molycote 1000 grease Embers smelling of 'fireworks' were...

Am I right in thinking that in a two stage recip compressor, each cylinder should have the same compression ratio, do an equal amount of work, and that the delivery temperature from each cylinder should be the same? I have just been speaking with a tech who's said that this is not the case...

I am trying to determine why the cooling circuit for our air compressors is not sufficient, and if there is a way of optimising it. We have a fin fan cooler, cooling the cooling water circuit. I wish to model the heat transfer in the system at different cooling water flow rates. I suspect...

Thankyou all for your replies regarding the condtion monitoring of recip compressors. Now can I venture another querie? I am trying to establish the best way to determine the running condition of each of our 4 compressors. We could carry out a full test involving flow rate measurement, power...

All, thankyou very much for your compreshensive replies. I shall let you know how I get on. Best regards, Neil.

We have have an Atlas Copco screw compressor on our rig.

I have been tasked to come up with a plan for the maintenance our compressed air system. I was wondering if anyone is aware of a good condition monitoring regime for recip air compressors. I'm interested in the state of the cylinders and of the pistons. Two ideas are listed below. -max...