Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Joecandraw

    Engineering ethics question

    ChipB you are wise to make a report on this problem and to even go to the point of having it recorded by a notary that is for your protection. But in no way sign off on this project until you are happy with a repair for the problem. The contractor errored that is easy to show. If you file a...
  2. Joecandraw

    Opinions on this column base

    I have seen this in Texas in application were store owners did not want to have exposed anchor bolts and desired to get shed of the column block outs. It works but like those before me i do not like it.
  3. Joecandraw

    Shear Transfer at Column Base Plates

    This is a great question. I believe the question is do you need to grout the oversized holes in the base plate. For reasons of hor. shear tranfer so as not to subject the anchor bolts to bending. The holes do not need to be grouted but oversized holes need min. 3/16 plate washers. The reason we...
  4. Joecandraw

    Hot-Tub on an Exterior Deck

    Good question i just got a hot tube myself. A 8 foot hot tub will weight about 1500 to 2000 pounds. So yes you need to support it. But to design a deck for it you need to know how high the deck will be off the ground. Two main factor: how are the post attacked to the ground and how is the deck...
  5. Joecandraw

    Overturning resistance of embedded post

    I have put my whole design team on the problem at hand. We feel that the architect should be consulted before the hole is dug. The rule of the day is the design is determined by the actually conditions of use. If it is a pole for a flying genny. Make a deep wide hole and use alot of...
  6. Joecandraw

    Existing Building Analysis Concrete Flat Plate

    Craig call the original design team if they are still around and ask them for there design cals.
  7. Joecandraw

    Beam Erection Seat

    Your design was for a shear tab that has the ablilty to bend. Your problem simple. You have a contractor that wants to erect on a seat angle to make erection faster. That appears to be fine. But if you take into consideration that there will also be a possible problem with a number of other...
  8. Joecandraw

    For AISC, which method, LRFD, or ASD, should one use ? ?

    ASD is perfered in the industry for many reasons. It is known to all the steel detailers and there software is set up for it. More over LRFD is not allowed in many areas because it has a building safty design factor that is marginal. In other words ASD is safer all around. In Areas with high...
Back
Top