I am using a PanelView 1000 and AB SLC5/04 PLC.
The screen I have set up consists of a maintained push-button for setting control mode (AUTO/MANUAL), a numeric entry block for setting the manual setpoint, and two monentary buttons to increment/decrement the setpoint in manual mode.
The issue...
We are using A Watlow D-8 to control 8 heaters. The D-8 uses 100ohm RTD inputs for control. During final assembly of the the prototype, we discovered 2 of the heater only have TCs.
Does anybody know of a way to convert a TC to RTD signal or if it is even possible?
Thanks in advance
js
I am recieving an error message when trying to check a modified assembly into Commonspace. The error is "Toolkit Error:-1". I have never seen it before and cannot find any info on it.
Any help will be appreciated.
JS
Over the weekend we upgraded to intralink 3.4. This morning all users are having issues printing. If a specific printer is selected from the print manager, nothing will print at all. If the print manager is used, and all printer setup is done through the windows manager, only a section of the...
We have a user who's .proi and other associated files are being created on the drive level rather thatn in his user folder. Where can I change the mapping for his .proi?
Thanks
The issue is fixed. There were missing references within the Family Table. As you said, the renaming had nothing to do with the problem. We had multiple users messing with the same family table.
Thanks
James
A family table instance was mistakenly renamed in commonspace of Intralink. While the generic model will open without failures, all instances fail when verify is run.
Any assistance is appreciated.
We are looking for a replacement for Pro/Diagram that will allow for the import of existing .DGM files without losing the paramentric information. Any ideas or direction would be appreciated.
Thanks
