Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Din 5480 Male Spline Dimensions?
gearguru Thanks for reply dated 23.06.05. In the past I have worked out strength of gears using the lewis formula, If I apply this to the 11t din spline and multiply the figure by 11(teeth) I have 6.66 factor of safety is this a fair way of doing this Regards Notrub- notrub
- Post #16
- Forum: Gear and Pulley engineering
-
Din 5480 Male Spline Dimensions?
gearguru (Automotive) Ref DIN5480 11T,1.25mod, internal spline . if we open bore of spline from 13.5 dia to 14.0 dia will this effect the engagement/running with the mating male spline the fit is 8H/8f.- notrub
- Post #12
- Forum: Gear and Pulley engineering
-
Din 5480 Male Spline Dimensions?
I am looking for over pin dims for following splines:- N16X1.25X30X8H-11TOOTH,1.25 MOD DIN5480-female W16X1.25X30X11X8f-11 TOOTH,1.2 MOD- MALE I have the spec but not part 14 Notrub- notrub
- Post #9
- Forum: Gear and Pulley engineering
