Hi EdStainless,
I have one more question if you would.
Is it possible for the spotweld itself to cause liquid metal embrittlement as well of the material? If so, I will need to let our vendor know and probably place a note on the drawing stating that spot welding is prohibited.
Thanks,
Trey
Typo:
...harsh environments which state the there should not be more than 0.15 Volt difference. Sited from http://www.corrosion-doctors.org/Definitions/galva...
Hello,
I have a galvanic/stress corrosion question for some of you material guru's if you don't mind.
The situation is that we have two 316 SST tubes are to be brazed together into another subassembly. Our vendor used a spot weld technique to keep the tubes together during the braze process...
Hey josephv, Yes. I guess it did not load. Here it is. Thanks for your time. Thttp://files.engineering.com/getfile.aspx?folder=cfc5e595-5e18-4ca8-bc05-560f9686f7fd&file=gap_condition_frequency.JPG
Hey Folks,
I have a question of how to simulate a bolt/screw when performing a frequency analysis in SolidWorks Simulation. The problem is that I have compression on a can but there are 4 screws that also come into play but have a gap between the plate they hold down and the threaded plate the...
