Thanks for joining in GregLocock & BillPSU.
I think we will push for a primary hole and a secondary slot in a direction that will accomodate the expansion. We have also discussed an aluminium frame for the component tooling mounted to a Steel Sub Frame - but I guess we just end up moving the...
Many thanks Kapitan / gwolf.
You are on the right lines when you mention Wings.
In the interests of confidentiality, I wish to say no more.
gwolf, you are correct with the "minimal restraint" approach. Not too sure of a rubber interface though. Have discussed encoding one end on a slide, with...
Many thanks Gwolf.
We are looking to locate the aluminium part at either end on some 20mm dia location pins, so it is a worry that after a period of time and with a variance of temperature, the part would 'lock' onto the pins.
Anyone else out there got suggestions?
Hello fellow engineers.
Tried searching for about a hour on the site, but can find nothing on this.
I am looking to design/manufacture an assembly fixture out of steel.
This fixture will be for aluminium components.
The components could measure around 20 Meters in length, 4 metres wide and a...
