Just FYI...I found it MUCH easier to copy and paste the "List Measurements" into Excel instead of saving as a text file. Too much post-formatting required with the text file. It would put multiple values that should be in separate columns in 1 cell, then you'd have to use the "Test to Columns"...
I'm running NX8.0 Motion Simulation trying to setup a suspension analysis. I'm wanting to output a 3D angle of moving joints to a spreadsheet. How can this be done with the "Measure" command? Or is there another command I should be using? See attached pic for better explanation.
I'm hoping...
I can see if it's +/- by viewing the "Information Window" for the dimension and seeing the "Delta Z" value, but how do I get that appropriate value to export to a spreadsheet?
I hope this is an easy question. I'm running an analysis and have an associated dimension attached to the end of a shaft measured to a datum plane. As this shaft moves, it can end up on either side of this plane. I would like for the dimension to show as either a positive or negative number...
