Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. rstock

    Suppliers for Mueller Valve Seals

    We have three Mueller 60" Lineseal III Butterfly Valves in our cooling tower. Recently, we were informed that we could not longer obtain the seal and bolt kits for these valves from Mueller as they no longer make the valves. The bolt kits are a lower priority, but we need the seals for our...
  2. rstock

    Suppliers for Mueller Valve Seals

    We have three Mueller 60" Lineseal III Butterfly Valves in our cooling tower. Recently, we were informed that we could not longer obtain the seal and bolt kits for these valves from Mueller as they no longer make the valves. The bolt kits are a lower priority, but we need the seals for our...
  3. rstock

    Good Combustion Training Courses

    I am looking to attend a good combustion training course in Canada or the US. Have you attended one recently that you thought was particularly useful? Do you have the info on who put on the course and what topics were covered? I'm looking at everything from basic combustion theory to...
  4. rstock

    Checking for Shaft Eccentricity with a Strobe

    I have a shaft that I suspect may have an eccentricity problem, and I am wondering if there is a procedure for checking for eccentricity with a strobe light. It is a three piece shaft through a screw pump. We could use a dial indicator on the straight stubs at the ends, but the centre section...
  5. rstock

    Universal Joint Max and Min Angles

    I have a universal joint connecting an actuator to a valve, and I need to determine if it's installation location does not cause the joint to exceed the maximum angle for that type of joint. Does anyone have a good reference that would give minimum and maximum angles for proper operation of a...
  6. rstock

    Input/output torque calculations

    Hi, there. Just reading through the responses here, and I think it answered a question of my own. I just wanted to check to make sure I'm not incorrectly applying the equations given. I have a 60" butterfly valve that is operated by an actuator through a gearbox. I know the torque required...

Part and Inventory Search

Back
Top