Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PipeOrganGuy

    Pulley reduction question?

    Thanks for helping me. I installed the motor, belt drive, and the Church has an Organ again. The speed was close enough to the same because the tuning of the pipes didnt change. Thank God, thats an all day affair to tune over 3,000 pipes. The bearings were fine, thats the first thing I...
  2. PipeOrganGuy

    Pulley reduction question?

    Hi, I’m new to this group so bare with me... I’m a Pipe Organ builder in Houston, TX. I have a blower motor from 1926 and the armature scraped the stator and burnt out the winding. My problem is the old brush motor ran at 1135 rpm and a new motor runs at 1740. (Single phase, 230 volt, 3hp)...

Part and Inventory Search

Back
Top