Search results for query: *

We were on teamcenter, but the box was exactly where I described above. When in NX you would go File > New, pick model and then enter the part number and description. Im hoping that even if its a teamcenter thing: 1. That New Menu can still be edited 2. If it could write the data to...

I am trying to customize the menu when you go File > New. When the menu opens and you select model and select one of the items, down below it has two boxes: Name: Folder: How do I go about adding a box for Description and then assigning it to an attribute? A previous job had this, and it was...

thanks so much for your help. Just for future reference how did you get the 8238in.lbs from the information you had and also is their a chart or list of different tube sizes and amterials. thanks

the 2 inch side would be vertical and the width would be 12 inches so 5.5" from center to center and they would be at a 30 degree angle from the ground thanks

I am considering building some aluminum ramps, that would be 5ft long. I was planning on making them out of 1 x 2 x .125 6061-t6 Tube. Each ramp would have three tubes running the 5ft length and have crossmembers joining them and then a .125 piece of Floor Plate over them. My questiion is...