Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. hhssbb2206

    Section VIII Div.1 - drainage

    Thanks, gr2vessels. I fully agree with your answer from an engineering point of view. However, is this code violation? Thanks. hhssbb2206
  2. hhssbb2206

    Section VIII Div.1 - drainage

    The channel side of U-tube heat exchanger under corrosive service has a nozzle located at hill side. The lowest edge of nozzle is higher 0.7 inch than the lowest point. "UG-25(f),Sec. Viii div.1, requires ' Vessels subject to corrosion shall be supplied with a suitable drain openin at the...
  3. hhssbb2206

    ASME PQR temperature

    Thanks great help!!
  4. hhssbb2206

    ASME PQR temperature

    I have question about the PQR of P-No.4, FCAW process without impact test ans with PWHT below lower transition temparature. A PQ test was conducted 8 year ago using ASEM 2001 Edtion. At that time, PWHT temperature required for VIII-div.1 was 1100 F minumum, but It had been changed from 2004...
  5. hhssbb2206

    PQR on ASME Section VIII div.2

    Regarding Article AT-202.3,Section VIII Div.2 I would like to know exact meaning of "(a)be of the same p-number and Group number". Does that mean the PQ test plates to be used shall be same P-no and Gr.-no regadless of Section IX requirements? QW 403.5 states that if i qualify a procedure...

Part and Inventory Search

Back
Top Bottom