Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
"pkelecy" Solidedge vs Solidworks
It seems to me that the GUI change was a bad decision. I have been using SE as my sole 3D design tool for ten years and the change of GUI has resulted in loss of productivity. This has made me to looking at replacment for SE. The most likely candidate is SW since it supports chain of tolerances...- PerBear
- Post #31
- Forum: Siemens: Solid Edge
-
UHMW bushing issues...
On www.igus.co.uk you will find over 7000 various polymer bearings under the Iglidur trade name. It is a German product and they have special material for subsea use (ROV's etc).- PerBear
- Post #9
- Forum: Polymer engineering
-
Material properties non-linear
Some polymer and elastomer material models for FEM analysis can be found at www.polymerfem.com It seems that most of it is made by ABAQUS users. -Per- PerBear
- Post #3
- Forum: Finite Element Analysis (FEA) engineering
-
Best machined Surface Finish for PEEK
I have specified Ra 0,2 um on some PEEK sealing surfaces. This is not achieavable by milling, only by polishing. This is a time-consuming operation that could increase cost a lot. You could also try heat treatment using the same 'lighter trick' normally used on scratched CDs, but PEEK has a much...- PerBear
- Post #7
- Forum: Polymer engineering
