Hello,
I currently have a european machine that has 2 touch buttons(Palm Buttons)made by Allen Bradley that activate a cycle.This touch button has a 5 pin qd connector the pins are as follows.
pin 1 Positive DC wire
pin 2 N.C white wire
pin 3 Negative DC wire
pin 4 N.O black wire
pin 5...
When I first ordered this VFD I was under the impression it would have dynamic braking(Which we thought was the solution).After receiving the drive we found out the Dyn braking was a add on option.After contacting the sales rep who contacted a engineering who was not on site at our plant to see...
I have a 20Ft conveyor moving "feathers"(On a conveyer belt that has a low coefficient of friction).This Motor has to stop right away with no coasting at all.This Belt is stopped by a sensor that in my opinion is to close to the 4th part ready to be picked.When this happens the 5th part is seen...
The Tolomatic Slide is run by a kevlar belt which pulls through a pulley system.no ball screw.The speed on the JVL motor is 9000 RPM 3000 Vel RPM.Torque is @ 300%.The Load Factor is set @ 2.1.
This application requires accuracy and speed.I find the the motor oscillates the most at the end...
Hello,
I have a JVL AC Servo Motor mounted directly to a Tolomatic Slide.This slide has a Kevlar belt.For the past 2 years we have been adjusting the Load Factor which affects the filter parameters every month or so.Recently I updated to the newer Firmware to get better control over the...