No, I don't. Our customer would have that, but I don't think that this is the issue because we have other customers who run the same material in larger machines, and hence larger blades that are also of the same material and we have not had these sort of problems. Those machines have been...
They were noticed after being run for a approximately 6 months of service. The blades do not turn continuously in one direction but are driven by a recipricating motor that turns them 3/4 of a turn one direction, then 3/4 turn back. At the end of each rotation, the blade comes to a hard stop...
My first time posting a thread on this site...
We have a SS mix blade weldment that through a couple of iterations is comprised of a 17-4PH SS Shaft, a 304 SS female coupling and (3) 304 SS Sheetmetal mix blades. After sending these blade weldments out to one of our customers, it was...
